Product Code Database
Silica gel is an amorphous and porosity form of silicon dioxide (silica), consisting of an irregular three-dimensional framework of alternating silicon and oxygen atoms with nanometer-scale voids and pores. The voids may contain water or some other liquids, or may be filled by gas or vacuum. In the last case, the material is properly called silica xerogel.
Silica xerogel with an average pore size of 2.4 nanometers has a strong affinity for water molecules and is widely used as a desiccant. It is hard and translucence, but considerably softer than massive silica glass or quartz, and remains hard when saturated with water.
Silica xerogel is usually commercialized as coarse granules or beads, a few millimeters in diameter. Some grains may contain small amounts of indicator substance that changes color when they have absorbed some water. Small paper envelopes containing silica xerogel pellets, usually with a "do not eat" warning, are often included in dry food packages to absorb any humidity that might cause decomposition of the food.
"Wet" silica gel, as may be freshly prepared from alkali silicate solutions, may vary in consistency from a soft transparent gel, similar to gelatin or agar, to a hard solid, namely a water-logged xerogel. It is sometimes used in laboratory processes, for example to suppress convection in liquids or prevent precipitation of suspended particles.
Stabilizing silica gel - non-crystalline micro-porous solid powder, nontoxic, flame-resisting, used in brewery of grains for beer to improve taste, clearness, color, and foam and for removal of non-micro-organism impurities.
Silica gel is able to adsorb up to 37% of its own weight in moisture in high-humidity environments. This moisture can be released upon heating at about for 1–2 hours. This makes it reusable multiple times with very little, if any, loss of efficiency.
Silica gel may also be used to keep the relative humidity inside a high frequency radio or satellite transmission system waveguide as low as possible (see also humidity buffering). Excessive moisture buildup within a waveguide can cause arcing inside the waveguide itself, damaging the power amplifier feeding it. Also, the beads of water that form and condense inside the waveguide change the characteristic impedance and frequency, degrading the signal. It is common for a small compressed air system (similar to a small home aquarium pump) to be employed to circulate the air inside the waveguide over a jar of silica gel.
Silica gel is also used to dry the air in industrial compressed air systems. Air from the compressor discharge flows through a bed of silica gel beads. The silica gel adsorbs moisture from the air, preventing damage at the point of use of the compressed air due to condensation or moisture. The same system is used to dry the compressed air on railway locomotives, where condensation and ice in the brake air pipes can lead to brake failure.
Prior to widespread use of air-conditioning, salt shakers with caps containing silica gel beads to keep the salt dry enough to prevent clumping were marketed in the US, replacing the practice of including a few grains of rice in salt shakers to effect the same drying.
Silica gel is sometimes used as a preservation tool to control relative humidity in museum and library exhibitions and storage.
Other applications include diagnostic test strips, inhalation devices, , drug test, and hospital sanitation kits.
Silica gel is commonly described as a way to remove moisture from phones and electronics accidentally exposed to water, but there are no known controlled studies that compare its actual efficacy compared to simple air or fan exposure. The average person is also unlikely to have a sufficient quantity of ready-to-use activated or regenerated silica gel.
Regenerating silica gel is important for both economic and environmental reasons. It can be regenerated thermally or chemically. Chemical methods involve the use of desiccating agents or solvents to desorb water from silica gel, though these are generally less practical for routine regeneration. Thermal regeneration can be applied also to packed silica gel beds without opening them, and can be done by conventional heating in an oven at a temperature around . Another option for thermal regeneration is by using microwaves to apply heat more evenly and reduce regeneration time compared to conventional ovens, but this process should be tightly controlled to avoid overheating. Yet another option to apply heat is using a solar heater with a compound parabolic concentrator. There are also studies on using ultrasonic waves to remove water molecules from silica gel at which are lower temperatures than that of conventional heating.
The hydroxy (OH) groups on the surface of silica can be functionalized to afford specialty silica gels that exhibit unique stationary phase parameters. These so-called functionalized silica gels are also used in organic synthesis and purification as insoluble reagents and scavengers.
Chelating groups have also been covalently bound to silica gel. These materials have the ability to remove metal ions selectively from aqueous solutions. Chelating groups can be covalently bound to polyamines that have been grafted onto a silica gel surface producing a material of greater mechanical integrity. Silica gel is also combined with to form a M-SG reducing agent. (See SiGNa chemistry)
Silica gel is not expected to biodegrade in either water or soil.
Listed uses include: anticaking agent, defoaming agent, stabilizer, adsorbent, carrier, conditioning agent, chill proofing agent, filter aid, emulsifying agent, viscosity control agent, and anti-settling agent. Silica can be found commonly in foods including baked goods, spices and herbs, dairy products, cocoa products, and more.
|
|
